Chicago Pneumatic SD25 Manuel d'instructions télécharger pdf (Page 37)

_____________________________________________________

CS4100/2100 Controllers Technical Reference

____________________________________________________________________________________________

September 2005 Page 35

Profibus Network Configuration

Before the module can be used on a Profibus-DP network some basic settings must be configured.

Baud Rate

The baud rate on a Profibus-DP network is set during configuration from the master. The module

features auto baud rate detection and the user does not have to configure the baudrate.

Supported baud rates:

1. 9.6 kbit/s

2. 19.2 kbit/s

3. 45.45 kbit/s

4. 93.75 kbit/s

5. 187.5 kbit/s

6. 500 kbit/s

7. 1.5 Mbit/s

8. 3 Mbit/s

9. 6 Mbit/s

10. 12 Mbit/s

Node Address

The switches can be used when selecting a node address in the range 00-99.

Termination

Each bus segment in a Profibus network must be terminated properly to ensure error-free operation.

If the module is used as the first or last node in a network, the termination switch has to be in ON

position. Otherwise the switch has to be in OFF position.

NOTE:

If an external termination connector is used, the switch must be

in the OFF position.

GSD Configuration file

A GSD file is available upon request which is applicable to this Profibus-DPV1 ANYBUS card.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 56 57

Pas de commentaire

Chicago Pneumatic SD25 Manuel d'instructions Page 37